Diy bud trimmer10/30/2022 No matter if you are a smaller cultivator, or a large-scale multi-state producer, there are bottlenecks in your process that cost you time, money, and labor. Simply put, the average hand trimmer can do 1-3 pounds in a day according to 2020 data, while even the smaller capacity bud trimmers in the industry can easily rock 4+ pounds per hour, with commercial machines boasting much higher numbers. EfficiencyĮfficiency is probably the biggest no-brainer on the list, but that’s what puts it into the top 5. And hey, health insurance isn’t bad either. So, bringing the right bud trimmer to your operation can help you and your staff spend less time in trim jail and more time where your business needs it. We even know cultivators who offer health insurance to their full-time trim QC team, which is amazing. Many of those companies are able to invest the savings from reduced hand-trimmed labor directly back into their company. Time after time I speak with cultivation staff who tell me they started with the company as a trimmer and have since moved on to a better, permanent position with the company once a mechanical bud trimmer was brought on.Īdditionally, companies that utilize certain bud trimmer s that allow control over the level of finish are retaining a smaller amount of full-time trimmer staff to perform final quality control over the product or to conduct the final trim by hand to still give the appeal of the hand-trimmed finish to their customers. However, when taking a more pragmatic look at the situation, there are many upsides to this reduction in the need for hand-trim labor.įirst, labor can be reassigned to other areas of production or harvest that could benefit from more attention. There’s obviously a lot of concern among human bud trimmers that machines and automation will push their craft out of work, as automation has historically done in mainstream industry. In this case, a trained machine operator can routinely reach a desired level o f trim with a bud trimmer, then kick it out and utilize their small in-house hand-trim team to do the final work, bringing a top shelf product to the marketplace at a fraction of the cost. As mentioned in the last section, there are companies in the cannabis space designing industry-born systems that keep the operator in control. T here are still costs associated with running, maintaining, and cleaning a bud trimmer, but it still leaves a substantial financial margin for cultivator s to reinvest into their business.Ī common misconception in the bud trimmer industry is that all machines are "in one end and out the other" or " You don’t get to control or customize the finish of your flower." That’s not true for all machines. The second ran through a bud trimmer until the operator saw it was 75% trimmed (could be 50%, could be 90%, the finish level is up to you) and then it was removed and finished by hand.īoth flowers look and test the same, but flower two cost you substantially less to produce as you elim in ated the first 75% of hand labor. The first bud was hand manicured 100% of the way, and you have the bill to prove it. Imagine that in front of you are two trimmed buds ready to be packaged and sent to the shelves. Cultivators are flocking to this new standard for automation because it is allowing them to decide on, and achieve, their desired flower finish, maintain the potency and cannabinoid profiles of their flower, and offer a more consistent product to their customers, all while offering the harvest cycle cost-savings that operations have been seeking for decades.Īutomation is not better.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |